Table of Contents
Advertisement
Blinking of the Tally Lamp
The tally lamp start blinking when the remaining space on the SD card is running out during recording, or
when the battery power is running low.
Blinking Mode
Blinks slowly
(once every second)
Blinks quickly
(2 times per second)
Warning Tone
Warning tone is output from the monitor speaker and [x] terminal when the battery level is low.
0
Warning tone is also output when an error occurs in the camera recorder.
0
Memo :
You can specify whether to turn on the warning tone as well as setting the volume in [A/V Set] B [Audio
0
Set] B [Alarm Level].
(A P112 [ Alarm Level ] )
Troubleshooting
Symptom
Power does not turn on.
Unable to start recording.
Camera image is not output on
the LCD monitor and
viewfinder screen.
Playback does not start after
selecting a clip thumbnail and
pressing the Set button (R).
Images on the LCD monitor
and viewfinder screen appear
dark or blurred.
174
Error Messages and Actions
Remaining Battery Power/SD Card Space
Battery power is low
0
Remaining recording time on SD card is less than 3 minutes (during
0
recording)
When a malfunction occurred during live streaming K
0
Remaining battery power is almost zero
0
Remaining recording time on SD card is zero (during recording)
0
Error on the camera recorder
0
Is the AC adapter properly connected?
0
Is the battery charged?
0
Is the power turned on immediately after it is turned off?
0
Make sure to wait for an interval of at least 5 seconds before turning
on the power again.
Is the record trigger button/lock switch on the handle turned on? O
0
Is the write-protect switch of the SD card turned on?
0
Make sure that the write-protect switch is turned off.
(A P40 [Write-Protect Switch on the SD Card] )
Is the camera recorder set to the Camera mode?
0
Use the [MODE] selection button to switch to the Camera mode.
(A P18 [Operation Modes] )
Is the SD card inserted compatible with the recording format?
0
(A P48 [Selecting a Video Format] )
(A P117 [ 4GB File Spanning(SDXC) ] )
Is the camera recorder set to the Camera mode?
0
Use the [MODE] selection button to switch to the Camera mode.
(A P18 [Operation Modes] )
Is the selected clip a playable clip?
0
Playback is not possible if the clip has a different video format setting.
Readjust the brightness of the LCD monitor and viewfinder.
0
Is the [ND FILTER] switch set to "1/16"?
0
Is the iris closed?
0
Is the shutter speed setting too high?
0
Is the amount of peaking too little? Use the [LCD/VF Peaking] menu
0
to adjust the contour for the LCD monitor image and viewfinder image
by adjusting the contour of the viewfinder image.
(The contour of the LCD monitor will also be adjusted at the same
time.)
Adjust using [Main Menu] B [LCD/VF] B [LCD/VF Peaking].
(A P37 [Adjusting the LCD Monitor] )
(A P38 [Adjusting the Viewfinder] )
Action
Advertisement
Table of Contents
