Setting The User's Bit - JVC GY-HM200U Instruction Manual

4 Check the values and press the Set button
(R).
The time code is set and the screen returns
0
to the normal screen.
To cancel the setting, press the [CANCEL]
0
button.
Caution :
When the camera recorder is switched to Media
0
mode during editing, editing will be canceled
and the screen will close.
When editing the time code, operation of the
0
buttons that are set in [Main Menu] B [Camera
Function] B [User Switch Set] is disabled.
[C.REVIEW/4] functions as the number reset
button.
(A P98 [User Switch Set Item] )
Recording Time Code in Continuation of
the Recorded Time Code on SD Card
This camera recorder is equipped with the time
code reader.
1 Set [TC/UB] B [TC Generator] to "Regen".
When the camera recorder enters from
0
recording standby mode to recording mode,
it reads the time code already recorded on
the SD card and records the new time code
in continuation of that value.
The same data as the user's bit already
0
recorded on the SD card is recorded.
Memo :
When [TC/UB] B [TC Generator] is set to
0
"Regen", the framing mode of the time code
follows the settings in [TC/UB] B [Drop Frame]
instead of the clip settings.
(A P104 [ Drop Frame ] )

Setting the User's Bit

You can add the date, time or an 8-digit
hexadecimal number as the user's bit to the
recorded image.
.
Selecting a Recording Mode
Recording date/time information to the user's
bit
1 Set [Main Menu] B [TC/UB] B [UB Mode] to
"Date" or "Time", and press the Set button
(R).
(A P103 [ UB Mode ] )
The date or time information is recorded to the
user's bit.
Memo :
When "Date" or "Time" is set, [Preset] appears
0
as "-" and cannot be set.
"Time" is displayed in the 24-hour format.
0
Presetting the User's Bit
Recording arbitrary information (8-digit
hexadecimal) to the user's bit
Setting Time Code Generator
71