Epson EMP-1825 Service Manual page 93

EMP-1825/EMP-1815/EMP-1810
Follow the procedure below to install the PS Ballast Assy.
C A U T I O N
1). Route the Lamp Cable (igniter not-attached side) as shown below.
2). Route the Lamp cable (igniter attached side) through the groove indicated
by the red box in the figure below. Make sure that the Lamp cable is not
routed under the PS Board.
SEIKO EPSON
Figure 4-59.
Lamp cable
Figure 4-60.
4-50
CONFIDENTIAL
hooks
Revision:C