Epson EMP-1825 Service Manual page 5

EMP-1825/EMP-1815/EMP-1810
Safety Instructions
The precautionary measures itemized below should be fully understood when performing repair and
maintenance procedures.
When disassembling/assembling, be sure to turn off the power switch and pull out
the power cable from the projector beforehand.
Never touch the current-carrying part or high temperature section during a test oper-
ation, signal measurement or any other situations that is necessary to perform the
repair/maintenance work with the power turned on and the cover removed.
Do not wear the metal products such as wrist watch, cuff buttons, rings, tiepin etc. to
avoid getting a electric shock.
Do not touch the lamp assy. or the parts around it. They are extremely hot even after
completed the cooling down operation, and may cause a burn injury.
Therefore, leave the unit until it becomes cool enough before performing mainte-
nance work.
Never let the safety devices mounted in this product inactivated for any reason what-
soever.
Never modify the safety devices or replace them with the ones that are not desig-
nated for any reason whatsoever. (Such actions may cause a fire or serious injury.)
Never modify the product for any reason whatsoever. (Except for a case that is under
the instructions to do so.)
Never peer through the projection lens during repair/maintenance work when the
power is on.
(Such an action may cause a visual disability because of a very strong light emis-
sion.)
Never use a deformed plug or a damaged power cable to this product.
If any deformations or damages are found on the power cable or plug section,
replace it with a new specified power cable.
Never use the air blowers that contain flammable gas in repair/maintenance work.
SEIKO EPSON 0-5
CONFIDENTIAL
Revision:C