Epson EMP-1825 Service Manual page 109

EMP-1825/EMP-1815/EMP-1810
• There must be over 50 cm from the floor level to the setting position of the projector.
(refer to Figure
• The projection distance must be within 100 cm ± 2 cm. (Projection distance: the distance
between the projector and the screen.)
Procedure
1. Set the projector according to the requirement written above.
2. Turn on the power and wait 5minutes until the Lamp's illumination is stabilized.
3. Adjust the focus of the projected image with the Focus Ring.
4. On the Control Panel, press both the [Help] and [QuickSetup] buttons for 5 seconds.
• A big "W (representing "Wide")" is displayed on the screen. [Pause Window 1]
5. Adjust the Zoom Ring manually to the Wide side to the end.
6. Adjust the focus of the projected image with the Focus Ring.
SEIKO EPSON
5-2)
Measure distance
between PJ's
frontmost and screen
Figure 5-2.
Figure 5-3. Pause Window 1
Screen
100cm 100cm 2cm 2cm
5-5
CONFIDENTIAL
Revision:C