Epson EMP-1825 Service Manual page 75

EMP-1825/EMP-1815/EMP-1810
Removing EMI Suppressor/EMI Suppressor E (EMP-1825's case)
C A U T I O N In EMP-1825's case, seven EMI Suppressor and two EMI Suppressor E are
attached on the back of the IM Board Assy. Refer to
attaching locations.
When replacing the IM Board Assy., refer to the instructions on the next page
and attach EMI Suppressor and EMI Suppressor E to the specified locations.
16).Remove the seven EMI Suppressors from the back of the IM Board Assy.
17).Remove the two EMI Suppressor E in the same manner.
Removing MA Shield Plate/Shield Plate Fasten (EMP-1810 only)
1).Remove the two screws (C.C.SCREW,3X6,F/ZN-3C) that secure the Shield Plate Fas-
ten, and remove the Shield Plate Fasten.
2).Remove the screw (C.B.P-TITE SCREW,2.5X10,F/ZN-3C) that secures the MA Shield
Plate, and remove the MA Shield Plate.
MA Shield Plate
C.B.P-TITE SCREW,
2.5X10,F/ZN-3C
SEIKO EPSON
IM Board Assy.
Figure 4-35.
Shield Plate Fasten
Figure 4-36.
4-32
Figure 4-37 (p. 33)
EMI Suppressor E
EMI Suppressor
CONFIDENTIAL
for
Revision:C