As (After Service) Menu; How To Display The As (After Service) Menu - Epson EMP-1825 Service Manual

EMP-1825/EMP-1815/EMP-1810
The contents of this chapter are for use only by Epson Authorized Services, and
C A U T I O N
are not to be disclosed to others without the express written consent of Epson.

6.1 AS (After Service) Menu

This menu provides information and settings that are not displayed on the standard menu.

6.1.1 How To Display the AS (After Service) Menu

1. Press the button either on the remote control or on the projector's control panel for at
[Menu]
least 5 seconds.
2. Within 4 seconds after pressing the
→ →
[Esc] [Esc] [Right]
AS Menu is displayed. (The items vary according to the input source.)
The video source's case. (Component, PC, HDMI, or D input (Page 1))
Input Signal Input Signal
Frequency Frequency
Sync Polarity Sync Polarity
Sync Mode Sync Mode
Detected Comp Mode Detected Comp Mode
Total Operation Time Total Operation Time
Lamp Op. Time (C) Lamp Op. Time (C)
(H/M/L) (H/M/L) : 0H/ ----H/ 0H
Lamp Replacement Lamp Replacement
Lamp ON/Lamp OFF Lamp ON/Lamp OFF
Cool Down Completed Cool Down Completed
Destination Destination
Engine Type Engine Type
P 0Z00023041XV111 P 0Z00023041XV111
O O 693021WWHAG1 693021WWHAG1
J J 0Z1XV100 0Z1XV100
SEIKO EPSON
button, hit these buttons in order shown below.
[Menu]
→
[Left]
XXXXXXXXXX XXXXXXXXXX
: XXXXXXXXXXXXXXXX : XXXXXXXXXXXXXXXX
: H ---.---KHz/ V ---.---Hz : H ---.---KHz/ V ---.---Hz
: H ---- : H ---- / V ---- / V ----
: ---- : ----
: XXXX : XXXX
: 0H : 0H
: 0H : 0H
: 0H/ ----H/ 0H
: 0Times : 0Times
: 0Times/ 0Times : 0Times/ 0Times
: 0Times : 0Times
: XXXX : XXXX
: XXXXXX : XXXXXX
6-2
CONFIDENTIAL
Source
The last four digits show the PW firm-
ware version.
The last four digits show the Sub-sys-
tem's firmware version.
Revision:C