Configuration and Operation
Authorised electrician
Coun-
try-spec.
Settings
EN
EN
All countries
All countries
All countries
All countries
All countries
IT-CEI021
Page 38
Menu
Display/
level
setting
Activate
1
2
3
3
or deactivate
password protection.
1
2
3
3
Starting voltage
1
2
3
3
Grnd fl t monitor
Internal
1
2
3
3
power
limitation
1
2
3
3
Set default power
1
2
3
3
Activate self-test
Action in this menu/meaning
Set min f_deact.
Set max f_deact.
NOTE: Set shutdown frequency for the power limitation
with rising and falling mains frequency in Hz.
Set T_deact
NOTE: Set minimum period (1- 1800s) during which the
inverter must remain within one frequency range until
P(f ) is deactivated.
Activate password protection for mains parameter
setting.
NOTE: After activation, only read access is available to the
mains parameter settings.
The inverter begins feed-in as soon as this PV voltage is
present.
Set the starting voltage.
One pole of the PV generator is grounded in the unit
using a fuse. Ground fault monitoring is triggered in the
event of an ground fault in the generator. This prevents
possible damage to the modules.
NOTE:
Activate ground fault monitoring only if you have
grounded one pole of the PV generator.
(See Section 7.3 on page 23)
Activate or deactivate the ground
fault monitoring function.
Power reduction is password-protected in some coun-
tries. Power is reduced in 10 W steps and is
limited to 50% of the nominal unit power.
Set power limiting.
Password protection can be re-activated.
Provides the option of maintaining the pre-confi gured
power limitation even in the event of a fault halting com-
munication.
Set power in xxxx / 1000 in ‰ (promille).
Set internal fall-back time to set default power if
external power reduction is not pending.
With an active self-test and feed-in operation, the switch-
off values for grid voltage and grid frequency are dis-
played.
Operating Instructions for Powador 2002-6002_EN