Kaco Powador 2002 Operating Instructions Manual page 35

Configuration and Operation
Coun- Menu
try-spec. level
Settings
1 2 2 3
1 2 2 3
1 2 2 3
1 2 2 3
1 2 2 3
All countries
1 2 2 3
1 2 2 3
Operating Instructions for Powador 2002-6002_EN
Display/
setting
Defi ning total
yield
Interface
Inverter address
S0 interface
Activate priwatt
Set priwatt
Quick start
Action in this menu/meaning
You can set the total yield to any value, for example, when
you have received a replacement unit and want to con-
tinue the recording from the present value.
 Select "yes" to set the total yield.
Select the RS232 or RS485 interface for data transmission
 The interface is changed by pressing "2".
Every inverter must have a unique address. The interface
is used to communicate with the Powador-proLog.
 By pressing key "2", the RS485 address can be set con-
secutively from 1 to 32.
Selection of pulse rate for the S0 interface
500, 1000 and 2000 pulses/kWh
 Set pulse rate.
Enables the use of the fault signal relay for the
Powador-priwatt internal consumption control relay.
 Activate or deactivate the home feed-in function.
NOTE: Activating this option enables the Set priwatt
menu option.
 Defi ne the switch-on power in kW that needs to be
available on an uninterrupted basis for 30 minutes
before the home feed-in is activated.
 Defi ne the switch-on time (operating time of Pow-
ador-priwatt after activation).
NOTE: This menu item is only available if you have
selected the "On" option for the "Activate priwatt" menu
item in the "Settings" menu.
Menu item is displayed only when waiting for grid feed
and during ramp-up limiting.
Off ers the option of ramping up the inverter faster for
inspection or testing.
If there is insuffi cient PV array power, the inverter stops
feeding into the grid after a short period of time.
 If the function is disabled, the display runs through
the menu level and when key "1" is pressed again it
shows the software version.
EN
Page 35