User Name And Password For System Initialization; Initializing The San Volume Controller 2145-Sv1 System By Using The Technician Port; Default User Name And Password For The Initialization Gui - IBM SAN Volume Controller 2145-SV1 Hardware Installation Manual

d. Click Custom level to customize the security level for this zone.
e. Scroll down to Downloads and select Enable under File download.
f. Click OK.
g. Click Yes to confirm.
h. Click OK to close the Internet Options.
For Microsoft Internet Explorer (IE) 11 and Microsoft Edge running on Microsoft Windows 10, file
download is enabled by default and requires no additional configuration.
4. Enable scripts to disable or replace menus. (Mozilla Firefox only).
For Mozilla Firefox:
a. On the menu bar in the Firefox browser window, click Tools > Options.
b. On the Options window, select Content.
c. Click Advanced by the Enable JavaScript setting.
d. Select Disable or replace context menus.
e. Click OK to close the Advanced window.
f. Click OK to close the Options window.
g. Refresh your browser.
5. Enable TLS 1.1/1.2 (Microsoft Internet Explorer 9 and 10 only).
For Microsoft Internet Explorer:
a) Open Internet Explorer.
b) Select Tools > Internet Options.
c) Select the Advanced tab.
d) Scroll to the Security section.
e) Check the Use TLS 1.1 and Use TLS 1.2 check box.
Note: IE 11 and later and Microsoft Edge enable TLS 1.1/1.2 by default.

User name and password for system initialization

During the initialization procedure, you need to log in to the initialization GUI for the system.
The default user name and password for the initialization GUI are listed in the following table.
Table 23. Default user name and password for the initialization GUI
User name
superuser
Note: The 0 character in the password is the number zero, not the letter "O".
Initializing the SAN Volume Controller 2145-SV1 system by using the
technician port
To initialize a new system, you must connect a personal computer to the technician port on the rear of a
node and run the initialization tool. This node becomes the configuration node and provides access to the
initialization GUI. Access the initialization GUI by using the management IP address through your IP
network or through the technician port. Use the initialization GUI to add each candidate node to the
system.
Password
passw0rd
Chapter 5. Initializing the SAN Volume Controller 2145-SV1 system 139