Table of Contents
Advertisement
Setting password protection
You can set up a password for accessing operator panel menus. When you have set
a password, access to the following operator panel functions is
password-protected:
v Changing configuration settings
v Importing and exporting cartridges
v Loading and unloading the tape drive
v Cleaning the tape drive
v Running demos
v Resetting the autoloader
A password can be up to six characters in length and is not case sensitive.
When password protection is in effect, you must enter the password before you
can use the operator panel menus. Each time you return to the Home screen and
press the Up a Level button an additional time (or wait 2 minutes), password
protection is reactivated; you must enter the password again to access the menus.
Attention: If you set a password record it in a secure location. The operator panel
functions cannot be used without the password.
Setting an operator panel password
To set a password for the operator panel, complete the following steps:
__ 1. On the operator panel, press the Down a Level button to display the main
__ 2. Press the Next Choice button to scroll through the menus until the Change a
__ 3. Press the Down a Level button once and then press the Next Choice button
__ 4. Press the Down a Level button. The Select Password Protection screen is
__ 5. Press the Next Choice button until ON is displayed.
__ 6. Press the Select button. The Select New Password screen is displayed.
__ 7. Press the Next or Previous Choice button to scroll through the available
24
87691VX VXA320 Tape Autoloader User's Guide
Menu
View a Status
Change a Configuration
Run a Diagnostic
menus.
Configuration menu is displayed.
until the Change Password Entry? screen is displayed.
displayed.
characters for each position. Press the Down a Level or Up a Level button to
change character positions. When you have entered the password, press the
Select button. The message Set Password Now? is displayed.
Description
Use this option to view an event log for the autoloader,
sensor readings, individual cartridge cell statistics, bar code
label information, cartridge inventory, firmware versions,
and serial numbers for the autoloader and tape drive.
Use this option to view and change the SCSI IDs, operating
mode, emulation mode, autoclean settings, and Ethernet
settings. Also use this option to set up a password to restrict
access to the operator panel menus.
Use this option to run demonstrations, perform diagnostic
tests, and reset the autoloader.
Advertisement
Table of Contents
