Lr/Elr Laser Scan Engine; Reader Settings Table; Appendix Iii - CipherLab 9500PPC Reference Manual

LR/ELR LASER SCAN ENGINE

The tables below list reader settings as well as symbology settings for the Long Range Laser (LR) or
Extra Long Range Laser (ELR) scan engine.

READER SETTINGS TABLE

LR/ELR
Decode Time-out
AIM Pattern
Read Redundancy
Level 1
Level 2
Level 3
Level 4
DESCRIPTION
Set the maximum time for decoding to continue during a
scan attempt.
1~9 (second) for ReaderCfg.exe – default to 3
5~99 (0.1 second) for programming – default to 30
Decide whether to have the aiming dot.
When you press the [SCAN] button, the scan engine
will emit a red dot for aiming. It will stay on until you
press the [SCAN] button again to emit a scan beam.
The following barcodes must be successfully read twice before being
decoded:
BARCODE TYPES
Codabar
MSI
Discrete 25 (=Industrial 25)
Interleaved 25
All barcodes must be successfully read twice before being decoded.
All barcodes except for the following barcodes must be successfully read
twice before being decoded. The following barcodes must be read three
times:
BARCODE TYPES "EXCLUDED"
MSI
Discrete 25 (=Industrial 25)
Interleaved 25
All barcodes must be successfully read three times before being decoded.

Appendix III

CODE LENGTH
All
4 characters of less
8 characters of less
8 characters of less
CODE LENGTH
4 characters of less
8 characters of less
8 characters of less
DEFAULT
3 sec.
Off
Level 1
83