Installing The Pistol Grip - CipherLab 9500PPC Reference Manual

Table of Contents

9500PPC Mobile Computer

INSTALLING THE PISTOL GRIP

This contoured pistol grip enables intuitive trigger-and-scan operation, which is very helpful in scan

intensive applications. When a pistol grip is necessary, install it to the mobile computer by following

these steps:

1) Place the mobile computer face down on a flat and clean surface.

2) Remove the shield-like cover on the back of the mobile computer by unscrewing.

If the hand strap is installed, remove it first. Keep the cover and screws for future use when the

pistol grip is not desired.

3) Connect the power connector from the pistol grip to the receptacle on the mobile computer.

4) Screw the pistol grip to the shield-like cover.

5) Make sure all screws are tightened up.

6) Turn on the mobile computer and test the trigger.

Figure 3: Installing the

Pistol Grip

Reference Manual

Table of Contents