Ccd/Laser Scan Engine; Reader Settings Table - CipherLab 9400CE Reference Manual

CCD/LASER SCAN ENGINE

The tables below list reader settings as well as symbology settings for the CCD or Laser scan engine.

READER SETTINGS TABLE

CCD/LASER
Scan Mode
Continuous Mode
Test Mode
Repeat Mode
Momentary Mode
Alternate Mode
Aiming Mode
Laser Mode
Auto Off Mode
Auto Power Off Mode Press the scan trigger to start with scanning.
DESCRIPTION
Non-stop scanning
To decode the same barcode repeatedly, move away the scan beam and
target it at the barcode for each scanning.
Non-stop scanning
Capable of decoding the same barcode repeatedly
Non-stop scanning
Capable of re-transmitting barcode data if triggering within one second
after a successful decoding
Hold down the scan trigger to start with scanning.
The scanning won't stop until you release the trigger.
Press the scan trigger to start with scanning.
The scanning won't stop until you press the trigger again.
Press the scan trigger to aim at a barcode. Within one second, press the
trigger again to decode the barcode.
The scanning won't stop until (a) a barcode is decoded or (b) the
pre-set timeout expires.
Hold down the scan trigger to start with scanning.
The scanning won't stop until (a) a barcode is read, (b) the preset
timeout expires, or (c) you release the trigger.
Press the scan trigger to start with scanning.
The scanning won't stop until (a) a barcode is read or (b) the preset
timeout expires.
The scanning won't stop until the preset timeout expires, and, the
preset timeout period re-counts after each successful decoding.
Appendix II
DEFAULT
Laser mode
87