Installing The Pistol Grip - CipherLab 8500 Reference Manual

8500 Series Mobile Computer

INSTALLING THE PISTOL GRIP

This contoured pistol grip enables intuitive trigger-and-scan operation, which is very
helpful in scan intensive applications. When the pistol grip is desired, install it to the
mobile computer by following these steps:
1) Place the mobile computer face down on a flat and clean surface.
2) Remove the shield-like cover on the back of the mobile computer by unscrewing.
If the hand strap is installed, remove it first. Keep the cover and screws for future use
when the pistol grip is not desired.
3) Connect the power connector from the pistol grip to the receptacle on the mobile
computer.
4) Screw the pistol grip to the shield-like cover.
5) Make sure all screws are tightened up.
6) Turn on the mobile computer and test the trigger.
Figure 3: Installing the Pistol Grip
4
Reference Manual