Maintaining And Replacing Light Sources; F150-Sl20A/Sl50A Maintenance - Omron V530-R150E-3 Operation Manual

Maintaining and Replacing Light Sources

7-1

Maintaining and Replacing Light Sources

7-1-1

F150-SL20A/SL50A Maintenance

Note The F150-LT10A Light Source cannot be connected to the older
Removing the Light Source
1,2,3...
!Caution
224
• The Light Source will gradually become dimmer as it is used
(approx. 20% dimmer after 1,500 hours of operation). Replace
the Light Source after approx. 1,500 hours of use.
• Replace the Light Source if it is partially damaged or not fully
functioning.
Part
Light Source
F150-S1 Cameras.
Light Source
1. Disconnect the light source cable from the light source connector
on the back of the Camera.
2. Remove the light source cable from the slot in the camera base.
3. Remove the two screws securing the Light Source.
4. Remove the Light Source from the Camera.
Do not disassemble the Lens.
F150-LT10A (See note.)
Camera base
Light source
connector
Section 7-1
Model number
Hold this section when
removing the Cable.
Camera cable
connector