Omron V530-R150E-3 Operation Manual page 214

System
3964(R)
1,2,3...
forcibly switch the Programmable Controller to MONITOR
mode.
The 3964(R) procedure controls data transmission via a point-to-
point connection between a Siemens product and a communications
partner.
1. The character delay time defines the maximum amount of time
permitted between two incoming characters within a message
frame.
Select 20 ms to 655350 ms in 10-ms increments.
The shortest character delay time depends on the baud rate.
1200 bits/s
2400 to 76800 bits/s
(Default setting: 220 ms)
2. The acknowledgment delay time defines the maximum amount of
time permitted for the partner's acknowledgment to arrive during
connection setup (time between STX and partner's DLE acknowl-
edgment) or release (time between DLE ETX and partner's DLE
acknowledgment).
Select 20 ms to 655350 ms in 10-ms increments.
The shortest acknowledgment delay time (ADT) depends on the
baud rate.
1200 bits/s
2400 to 76800 bits/s
(Default setting: 2000 ms)
Cha. delay time : [ 22]x10ms
Ack. delay time : [ 200]x10ms
Setup att. count : [ 6]
trans. att. count : [ 6]
Master/Slave : Slave
300 bits/s 60 ms
600 bits/s 40 ms
30 ms
20 ms
300 bits/s 60 ms
600 bits/s 40 ms
30 ms
20 ms
Section 6-4
3964(R)
197