Upper Housing / Printer Cover - Epson WorkForce 1100 Service Manual

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100

4.2.7 Upper Housing / Printer Cover

1. Remove the Decoration Plate Left/Right. (p.71)
2. Remove the Panel Unit. (p.69)
3. Remove the seven C.B.P. M3 x 10 screws that secure the Upper Housing.
4. Remove the Upper Housing while pulling out the Panel FFC through the cutout of
the Upper Housing.
1) C.B.P. M3x10
(6±1 kgf.cm)
6
1) C.B.P. M3x10 1) C.B.P. M3x10
(6±1 kgf.cm) (6±1 kgf.cm)
5
2
Figure 4-15. Remove the Upper Housing
Disassembly And Assembly
1) C.B.P. M3x10
(6±1 kgf.cm)
7
Upper Housing
1) C.B.P. M3x10
(6±1 kgf.cm)
3
4
1
Removing the Housings
 Route the Panel FFC correctly as shown in
 Install the Upper Housing so that the Grounding Plate properly
protrudes through the cutout of the Upper Housing.
Upper Housing
Grounding Plate
Figure 4-16. Routing the Panel FFC
 Tighten the screws in the order shown in
After replacing the following parts, be sure to apply G-74 grease to the
A D J U S T M E N T
R E Q U I R E D
area specified for each part.

Upper Housing: See Figure 6-14 on page 158.
Revision C
Figure 4-12.
Figure 4-15.
72
Confidential