Epson WorkForce 1100 Service Manual page 116

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
7. Remove the guide pin of Left Bushing 8 from the Main Frame using tweezers, and
rotate the Bushing upwards to align with the notch on the Main Frame.
Left Bushing 8
Figure 4-136. Rotating the Left Bushing 8
When performing the following procedure, take care not to lose the
C A U T I O N
E-ring.
8. Remove the E-ring from the PF Roller Shaft with a flathead screwdriver, and slide
Left Bushing 8 to the inside of the Printer Mechanism.
Figure 4-137. Removing the Left Bushing 8
Disassembly And Assembly
Notch
Guide pin
E-Ring
PF Roller Shaft
Disassembling the Printer Mechanism
When performing the following procedure, pay attention to the
C A U T I O N
following points.
 Prevent the coated surface of the PF Roller Shaft from being
scratched.
 Do not touch the coated surface of the PF Roller Shaft with
bare hands.
Figure 4-138. Handling the PF Roller Shaft
9. Remove the PF Roller Shaft from the Bushings on the Rear Paper Guide and the
Center Support, slide the PF Roller Shaft to the left to remove it from Right
Bushing 8, and remove the PF Roller Shaft along the notch of the Main Frame.
Rear Paper Guide
Notch
Figure 4-139. Removing the PF Roller Shaft
Coating Part
Bushings Center Support
Right Bushing 8
Confidential
Revision C
116