Epson WorkForce 1100 Service Manual page 91

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
11. Remove the CR Drive Belt from the CR Motor Pinion Gear.
Figure 4-65. Removing the CR Drive Belt
12. Remove the four C.B.S. (P4) M3 x 6 screws that secure the CR Guide Plate, and
remove it from the Main Frame.
8) C.B.S. (P4) M3x6
(8±1 kgf.cm) CR Guide Plate
4 3
Figure 4-66. Removing the CR Guide Plate
 Align the positioning holes on the CR Guide Plate with the
seven tabs on the Main Frame.
 Tighten the screws in the order shown in
Disassembly And Assembly
CR Drive Belt
CR Motor Pinion Gear
8) C.B.S. (P4) M3x6
(8±1 kgf.cm)
2
1
Tabs
See Figure 4-66 (p.91)
Figure 4-66.
Disassembling the Printer Mechanism
13. Loosen the C.B.S. (P4) M3 x 8 screw that secures the Left Parallelism Adjust
Bushing, and rotate the Bushing toward the front of the Printer Mechanism to
prevent interference between the Flag of the Parallelism Adjust Bushing and the
Left PG Cam.
Flag of the Parallelism Adjust Bushing (Left)
Left PG Cam
Figure 4-67. Rotating the Left Parallelism Adjust Bushing
14. Slide the Left CR Shaft Mounting Plate upwards, and release the tab on the Left
CR Shaft Mounting Plate from the notch on the Main Frame to rotate the
Mounting Plate toward you.
Tab
Figure 4-68. Rotating the Left CR Shaft Mounting Plate
Revision C
6) C.B.S. (P4) M3x8
(5±1 kgf.cm)
Left CR Shaft
Mounting Plate
Confidential
91