Epson WorkForce 1100 Service Manual page 93

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
Install the Right PG Cam so that one of these positions marked "0",
"+" or "++" faces downward.
Figure 4-73. Right PG Cam Installation Direction
19. Pull the Right CR Shaft Mounting Plate away from the tab on the Main Frame and
rotate toward you.
Figure 4-74. Rotating the Right CR Shaft Mounting Plate
Disassembly And Assembly
Right CR Shaft
Mounting Plate
Tabs
Disassembling the Printer Mechanism
When performing the following procedure, take care not to scratch
C A U T I O N
the Carriage Shaft.
20. Slide the Carriage Unit to the left side to prevent the CR Scale Cover from
interfering with the rear of the Carriage Unit, slide the Carriage Shaft to the left
side and pull out its right end from the Main Frame, and pull out the Carriage Shaft
from the Main Frame and Carriage Unit.
Point of
Interference
Carriage Unit
2
Figure 4-75. Removing the Carriage Shaft
Revision C
CR Scale Cover
Carriage Shaft
3
1
93
Confidential