Printhead / Csic Assy - Epson WorkForce 1100 Service Manual

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
 Pass the CR Scale through the slot on the CR Encoder.
CR Encoder
CR Scale
Figure 4-35. Reinstalling the CR Scale (1)
 Set the left end of the CR Scale with the black mark facing
upwards.
Black Mark
CR Scale
Figure 4-36. Reinstalling the CR Scale (2)
 Place the right end of the CR Scale correctly so that it is not
hooked onto the Right CR Shaft Mounting Plate.
CR Scale
Figure 4-37. Reinstalling the CR Scale (3)
Disassembly And Assembly

4.4.3 Printhead / CSIC Assy

C A U T I O N
1. Remove the Upper Housing / Printer Cover. (p.72)
2. Release the Carriage Lock, and move the Carriage Unit to the center.
(Refer to 4.1.5 Locking/Releasing the Carriage (p.65).)
3. Open the Ink Cartridge Cover.
4. Cut the Hinge, Cover Cartridge with a nipper or a similar tool and remove the
upper part of the Hinge, Cover Cartridge.
5. Remove the Ink Cartridge Cover from the Carriage Unit.
6. Disengage the hook from the lower part of the Hinge, Cover Cartridge using a pair
of Tweezers and remove the lower part of the Hinge, Cover Cartridge.
OK
Hinge, Cover Cartridge
NG
Hooked Portion
Disassembling the Printer Mechanism
So as not to damage the FFC, do not use any tools with the sharp
ends when removing the Cable Holder.
Ink Cartridge Cover
Cartridge upper part
Hook
lower part
Figure 4-38. Removing the Hinge, Cover Cartridge
Revision C
Hinge, Cover
81
Confidential