When Using Snapopc+ (Sdvs And Sdpvs) - Fujitsu ETERNUS DX100 S3 Setup Manual

Chapter 4 Configuration Settings for RAID Groups or Thin Provisioning

4.3 When Using SnapOPC+ (SDVs and SDPVs)

4.3 When Using SnapOPC+ (SDVs and SDPVs)
The following section describes the series of environment settings when using SnapOPC+ (SDVs and SDPVs).
Not only can new RAID groups be created, adding or changing volumes that are registered in existing RAID
groups can also be performed.
Create RAID Group
a group of drives that configures the RAID in the ETERNUS DX
Create a RAID group (
Refer to:
-
"RAID Group Creation" in "FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system
Configuration Guide (Basic)"
-
"RAID Group Creation" in "FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system
Configuration Guide (Basic)"
-
"RAID Group Creation" in "FUJITSU Storage ETERNUS DX200F All Flash Array Configuration
Guide (Basic)"
Create Volume
Create a volume (drive area in the RAID group). A volume is a structural unit of RAID that can be
recognized from the server. Select "SDV" or "SDPV" for "Type".
Refer to:
-
"Generation Management Volume (SDV) Creation" or "Temporary Work Volume (SDPV) Cre-
ation" in "FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration
Guide (Basic)"
-
"Generation Management Volume (SDV) Creation" or "Temporary Work Volume (SDPV) Cre-
ation" in "FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration
Guide (Basic)"
-
"Generation Management Volume (SDV) Creation" or "Temporary Work Volume (SDPV) Cre-
ation" in "FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)"
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED
53
).
P2X0-1250-06ENZ0