Fujitsu ETERNUS DX100 S3 Setup Manual page 61

Chapter 4 Configuration Settings for RAID Groups or Thin Provisioning
4.4 When Using Thin Provisioning Volumes (TPVs)
4
Select the Controlling CM of the RAID group and all of the drives that are to be registered in
the RAID group from the list or from the installation image.
■ When selecting drives from the list
Click the [Tabular] tab to select drives from the list.
Only unused drives are displayed on the list.
The main setting item is as follows.
• Checkbox to select drives
■ When selecting drives from the list
Click the [Graphic] tab to select drives from the drive installation image.
The installation images of all the drives installed in the ETERNUS DX are displayed. Checkboxes are
displayed for unused drives.
The main setting item is as follows.
• DE selection list box
• Checkbox to select drives
When SSD-Ms with an interface speed of 12Gbit/s are installed in a high-density drive enclosure, the
SSDs operate at 6Gbit/s because the interface speed of the high-density drive enclosure is 6Gbit/s.
• To check the number of member drives of the RAID group, click the [RAID Level] link for the
existing RAID group. The drives with the checkbox selected in the displayed screen are the
member of the RAID group.
• Click the [RAID Level] link to change the Controlling CM and configuration drives of the RAID
group.
• Click the [Delete] button to delete a RAID group.
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED
61
P2X0-1250-06ENZ0