When Using Standard Volumes - Fujitsu ETERNUS DX100 S3 Setup Manual

Chapter 4 Configuration Settings for RAID Groups or Thin Provisioning

4.2 When Using Standard Volumes

4.2 When Using Standard Volumes
The following section describes the series of settings when creating Standard volumes.
Not only can new RAID groups be created, adding or changing volumes that are registered in existing RAID
groups can be performed.
Standard volumes are also used as copy destination volumes for OPC, EC, or REC.
Create RAID Group
a group of drives that configures the RAID in the ETERNUS DX
Create a RAID group (
Refer to:
-
"RAID Group Creation" in "FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system
Configuration Guide (Basic)"
-
"RAID Group Creation" in "FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system
Configuration Guide (Basic)"
-
"RAID Group Creation" in "FUJITSU Storage ETERNUS DX200F All Flash Array Configuration
Guide (Basic)"
Create Volume
Create a volume (drive area in the RAID group). A volume is a structural unit of RAID that can be
recognized from the server. Select "Standard" for "Type".
Refer to:
-
"Operation Volume Creation" in "FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage
system Configuration Guide (Basic)"
-
"Operation Volume Creation" in "FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage
system Configuration Guide (Basic)"
-
"Operation Volume Creation" in "FUJITSU Storage ETERNUS DX200F All Flash Array Configura-
tion Guide (Basic)"
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED
52
).
P2X0-1250-06ENZ0