Toshiba e-STUDIO281c Service Manual page 372

(7) Remove 1 E-ring and pull out the shaft. Then
remove 8 exit fingers and 1 actuator.
(8) Remove 1 screw.
(9) Enlarge the frame and take off the transport
guide.
[L] Exit roller
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Open the jam access cover of the fuser unit.
(3) Remove 2 screws (one of the front side is a
shoulder screw) and take off the exit roller
cover.
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
Transport guide
2
Exit roller cover
16 - 32
E-ring
Fig.16-49
3
1
Fig.16-50
Shoulder screw
Fig.16-51
June 2005 © TOSHIBA TEC