Toshiba e-STUDIO281c Service Manual page 288

(9) Take off the developer sleeve.
* Procedure for replacing an oil seal:
P.12-32 "Fig.12-63 "
[A-6] Mixer
(1) Discharge the developer material
( P.12-16 "[A-2] Developer material").
(2) Take off the developer sleeve
( P.12-18 "[A-5] Developer sleeve").
(3) Front side: Remove the following parts
installed on the shaft of each mixer in order:
E-ring, bushing-1 and bushing-2.
* Procedure for replacing an oil seal:
P.12-32 "Fig.12-63 "
(4) Rear side: Remove the following parts
installed on the shaft of each mixer in order:
E-ring, gear, bearing and oil seal.
* Procedure for replacing an oil seal:
P.12-32 "Fig.12-63 "
e-STUDIO281c/351c/451c DEVELOPER UNIT
Developer sleeve
Bushing-2
E-ring
12 - 20
Fig.12-26
E-ring
Bushing-1
Fig.12-27
E-ring
Gear
Fig.12-28
June 2005 © TOSHIBA TEC