Toshiba e-STUDIO281c Service Manual page 243

(5) Take off the transport motor drive unit
( P.9-14 "[E] Transport motor drive unit").
(6) Remove 1 clip and 1 bushing each from the
front and rear sides.
(7) Take off the registration roller (rubber roller)
while sliding it to the rear side.
(8) Remove 1 spring, 1 clip and 1 bushing each
from the front and rear sides.
(9) Take off the registration roller (metal roller)
while sliding it to the rear side.
Note:
When installing the springs, make sure not to
mix up the front and rear side spring since
they are different. The rear side spring is
marked in black.
[M] Intermediate guide (Paper dust removal brush)
(1) Loosen 1 screw and take off the intermediate
guide by sliding to the rear side.
June 2005 © TOSHIBA TEC
Clip
Registration roller ( rubber roller )
Bushing
Fig.10-71
Bushing
Clip
Spring
Fig.10-72
Intermediate guide
Fig.10-73
e-STUDIO281c/351c/451c PAPER FEEDING SYSTEM
10 - 31
05/08
Clip
Bushing
Spring
Clip
Bushing
Registration roller ( metal roller )
10