Toshiba e-STUDIO281c Service Manual page 228

[A-10] Bypass transport roller
(1) Take off the bypass upper guide (
"[A-5] Bypass upper guide").
(2) Remove the E-ring, pull out the shaft and
take off the bypass transport roller.
[A-11] Bypass feed clutch (CLT6)
(1) Take off the bypass tray and hinge assembly
( P.10-10 "[A-2] Hinge assembly").
(2) Disconnect 1 connector and release the har-
ness clamp.
(3) Remove the harness clamp.
(4) Remove 3 screws and take off the bracket.
(5) Remove the bushing and the bypass feed
clutch.
Note:
Match the protruding portion of the clutch
and bracket for assembling.
e-STUDIO281c/351c/451c PAPER FEEDING SYSTEM
P.10-13
Connector
10 - 16
05/08
E-ring
Bypass transport roller
Bushing
Fig.10-27
Harness clamp
Fig.10-28
Bypass feed clutch
Bushing
Bracket
Fig.10-29
June 2005 © TOSHIBA TEC
Bushing