Toshiba e-STUDIO281c Service Manual page 366

(5) Remove 1 E-ring. Then remove 1 bearing.
(6) Lift up the separation roller by sliding it.
(7) Take off the fuser belt.
Note:
When installing the fuser belt, place a sheet
of paper between the separation plate and
fuser belt in order to prevent the fuser belt
from being scratched by the separation plate.
Keep the paper between then until the fuser
roller is installed.
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
Fuser belt
Fuser belt
16 - 26
E-ring
Bearing
Fig.16-31
Separation roller
Fig.16-32
Peper
Fig.16-33
June 2005 © TOSHIBA TEC