Toshiba e-STUDIO281c Service Manual page 325

(4) Remove 1 screw and take off the bracket on
the rear side.
(5) Pull the bearing attached on the 2nd transfer
facing roller out of the hole and then insert it
into the adjacent hole.
(6) Pull out the transfer belt.
Notes:
1. Install the transfer belt in the middle so
that it does not move to one side.
2. Install the transfer belt with the reflection
tape on the inner side of the belt come at
the rear side.
3. Do not touch the belt surface directly with
bare hands.
4. Be sure not to scratch the belt surface.
5. When the belt is being replaced, clean its
drive roller, 2nd transfer facing roller, ten-
sion roller, idling roller and 2nd transfer
guide roller with alcohol.
6. Check if the flange on both ends of the
transfer belt does not run on the rollers.
June 2005 © TOSHIBA TEC
Fig.14-12
Fig.14-13
Transfer belt
Fig.14-14
e-STUDIO281c/351c/451c TRANSFER UNIT
14 - 11
Bracket
14