Toshiba e-STUDIO281c Service Manual page 163

[D] Exposure lamp (EXP)
(1) Take off the original glass and front upper
cover ( P.6-17 "[A] Original glass",
P.2-27 "[G] Front upper cover").
(2) Move the carriage-1 to the center position.
(3) Disconnect the connector of the exposure
lamp.
Note:
When disconnecting the connector, pay
attention not to give load to the carriage
frame.
(4) Release the harness from the harness
clamp.
(5) Move the carriage-1 to the position where
the side of the frame is cut out.
June 2005 © TOSHIBA TEC
Fig.6-24
Fig.6-25
Fig.6-26
6 - 19
e-STUDIO281c/351c/451c SCANNER
6