Toshiba e-STUDIO281c Service Manual page 290

(3) Take off the left cover (
cover").
(4) Lift up the revolver lock lever and rotate the
revolver manually until it is locked.
Notes:
1. Do not touch the sleeve with bare hands.
2. When rotating the revolver automatically,
start up the equipment in the Test Mode
(03) and use the following codes.
03-455: Yellow developer unit moves to
the replacement position.
03-456: Magenta developer unit moves to
the replacement position.
03-457: Cyan developer unit moves to the
replacement position.
(5) Loosen 2 screws on each holder and take off
the holder on both sides of the color devel-
oper unit.
(6) Take off the color developer unit.
Note:
If the other color developer units still need to
be replaced, repeat steps (4) to (6). When
rotating the revolver manually, push down
the revolver lock lever and rotate the revolver
slightly, and then pull up the lever again.
e-STUDIO281c/351c/451c DEVELOPER UNIT
P.2-29 "[K] Left
12 - 22
Lock lever
Fig.12-31
Holder
Holder
Fig.12-32
Color developer unit
Fig.12-33
June 2005 © TOSHIBA TEC