Lighting Systems; Baitwell Light - Pro-Line Boats 2006 29 super sport Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

To activate the pump manually, depress the switch to the up or forward position. This action will

drain the fish boxes of water and/or debris, transport it into the collector box/holding tank and

then to the macerator pump to be macerated and/or discharged overboard.

When not in use, the switch should be left in the off or down position. Even though your Pro-

Line is equipped with a true gutter system, sometimes water will accumulate in the fish boxes.

As long as there is power to the fish box macerator pump, the automatic float switches located

in the holding tank will activate the pump and automatically discharge the water overboard.

Horn - The horn is used to signal, warn, or alert other boats, swimmers or people on shore.

Depress the horn switch to the up or forward position to activate the horn. Release the horn

switch to deactivate the horn. Using different sequences of horn blasts indicates different and

sometimes dangerous situations to you or someone around you.

Avoid any horn use without an appropriate purpose. See the Safety Section in this manual

and/or take a safe boating course for more information on the proper use of the horn.

Baitwell Pump - The baitwell pump is located in the bilge area and is mounted on a seacock

(ball valve). For the baitwell pump to operate properly you need to make sure the seacock is in

the open position. The seacock is wide open when the yellow seacock lever is vertical. When

the yellow seacock lever is horizontal, the seacock is closed.

The underside of the seacock thru-hull is equipped with a scoop to allow the water to be picked

up even when the boat is on plane. When the boat is not in the water or the baitwell pump is not

going to be used for an extended period of time, the seacock valve should be in the closed

position.

To activate the pump, depress the switch to the up or forward position. To turn the pump off

after the baitwell tub is full, depress switch to the down or aft position.

Washdown Pump - To activate the pump, which is located in the bilge, depress the switch to the

up or forward position. The washdown pump draws its water from the same seacock that the

baitwell pump draws its water. To turn the pump off, depress the switch in the down position.

Keep the washdown switch in the off position if the pump is not going to be used soon.

Aft Fish Box Pump – Please refer to the instructions provided for the Forward Fish Box Pump

(#6) shown above.

Fresh Water – The fresh water switch directs power to the fresh water pump. Depress the fresh

water switch to the forward position to activate the fresh water pump. Then, go to the port aft

corner of the cockpit, retrieve the fresh water faucet/nozzle and press the button on the handle.

If the fresh water system is not going to be in use, move the switch to the down position to turn

the pump off.

12, 13

Accessory - These 2 accessory switches can be used for additional dealer installed accessories.

Please check the amp rating of any new component and/or additional accessory before

installation. These switches are rated for 5 amps.