Section 2 Fax Operation (Various Functions); Duplex Transmission - Kyocera FAX SYSTEM Operation Manual

Section 2 Fax Operation (Various Functions)

Duplex Transmission

Duplex Transmission enables the transmission of both the front and back sides of duplex (2-sided) documents. Duplex transmission is always
accomplished by setting the documents you want to transmit in the Duplex Document Processor and scanning them into memory in the
Memory Transmission mode.
During the set-up procedure for a Duplex Transmission, it is possible to select whether or not you want to include a separate cover page with
the transmission as well as whether the image on the back side of the document needs to be inverted during transmission to match the
orientation of the image on the front side.
It is also possible to use Duplex Transmission capabilities in combination with each of the other various types of fax communication available
in this fax. The following method explains the procedure for sending duplex documents to a single destination.
* Prior to performing Duplex Transmission, you must select "Standard
size" when setting the document size for scanning from the
Document Processor. (Refer to "Setting the Document Size for
Scanning from the Document Processor" on page 6-4.)
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1. Set the 2-sided documents in the Duplex Document Processor.
2. Enter the destination fax number.
* If you entered the fax number using the keypad, go to the next
step.
If you entered the fax number using abbreviated numbers, one-
touch keys, group dial keys, program keys or chain dial keys,
proceed directly to step 4.
(Inch)
(Metric)
Section 2 Fax Operation (Various Functions)
3. Touch the "Duplex TX" key and then go directly to step 6.
4. Touch the "TX setting" key.
(Inch)
(Metric)
5. Touch the "Duplex TX" key.
6. Touch the "On" key to enable Duplex Transmission.
2-1