Error Code Tables - Kyocera FAX SYSTEM Operation Manual

Error Code Tables

When a communications error occurs, one of the following error codes will be printed out on the corresponding Transmission Report or Reception
Report as well as the Activity Report.
Refer to the following tables for a more detailed explanation of the error.
* If an error occurs during communication at a transmission speed of 33600 bps, the "U" in the error codes noted below will change to an "E".
CODE CAUSE AND/OR PROCEDURE FOR CORRECTION
The line is busy or the other party does not answer after automatically redialling the set number of times.
Busy
Perform transmission or reception procedures again.
Transmission has been interrupted by pressing the Stop/Clear key.
Reception has been interrupted by pressing the Stop/Clear key.
Stopped
During multiple communication (Broadcast Transmission, Polling Reception, etc.), this unit was unable to transmit
to all destinations due to a communications interruption.
U00300 The destination FAX has run out of recording paper. Check with the destination party.
U00420 -
Connection was made on a call initiated by the transmitting party, but the transmission has been interrupted because
U00462
the transmitting party does not possess the necessary communication capabilities.
U00600 -
Communication was interrupted due to trouble with your unit. Perform transmission or reception procedures again.
U00690
Communication was interrupted due to trouble with the other party's FAX unit. Check with the other party.
U00700
U00800
Unsuccessfully transmitted page(s) remain. Perform transmission procedures again.
U00810
U00900
Unsuccessfully received page(s) remain. Perform reception procedures again.
U00910
U01000 -
A communication error occurred during transmission. Perform transmission procedures again.
U01092
U01100 -
A communication error occurred during reception. Perform reception procedures again.
U01199
A communication which uses the timer was scheduled, and a number was entered using an abbreviated number or
U01400 one-touch key, etc., but communication with that party was impossible because that number was no longer registered
when the scheduled time arrived. Check your unit.
A communication error occurred during transmission at high transmission speed. Perform transmission procedures
U01500
again.
A communication error occurred during reception at high transmission speed. Perform reception procedures again
U01600
after having the transmitting party lower the transmission speed.
U01700 A communication error occurred during transmission at high transmission speed. Perform transmission procedures
U01720 again.
Section 9 Reference Information
9-7