G Making Copies During A Reception; G Memory Reception - Kyocera FAX SYSTEM Operation Manual

Section 1 Fax Operation (Basic Use)
Receiving a fax
1
When a fax comes in, fax reception will begin automatically
after the amount of time equal to a designated number of
rings.
* Once fax reception begins, the "Status" ["Act status"] key will
appear in the bottom right of the touch panel.
(Inch)
(Metric)
> Stopping the reception in progress
1 Touch the "Status" ["Act status"] key in the bottom right of
the touch panel.
2 Touch the "Stop" key and the reception will be canceled.
(Inch)
(Metric)
Printing out the received documents
2
Received document(s) will be printed out and ejected face-
down in the copy store section.
1-20

G Making copies during a reception

It is possible to make copies even during a reception in which
documents are being directly printed out (whereby Imaging memory is
not used to save the documents).
• Press the Interrupt key during a reception. The fax will switch to
Memory Reception and copying will be possible.

G Memory Reception

When you cannot print out because paper has run out or a paper jam
occurs, the data for all received documents will be temporarily stored
in memory and will then be printed out automatically once printing is
enabled.
* If, for any reason, power to the fax is disconnected or lost,
data received into memory may be lost. Ask the other party
to retransmit any documents for which data was lost.
* Up to 250 sheets of plain paper can be stored in the copy store
section at one time. When the maximum number of sheets has been
reached, remove all of the documents from the copy store section.
* Even if you cannot print out because paper has run out or a paper
jam occurs, reception is still possible (Memory Reception).
* 8 MB of optional memory must be installed in order to use the Ultra
fine resolution.