Printing Out An F-Code Relay Box List - Kyocera FAX SYSTEM Operation Manual

Section 4 Other Features of this Fax
3. Touch the "Subadd." key.
4. Touch the "On" key.
(Inch)
(Metric)
5. Use the keypad to enter the appropriate subaddress.
* This subaddress is required during an F-Code Based
Communication in order to designate the box in the destination
party's fax. It can be up to 20 digits in length and can include any
combination of the numerals 0 - 9.
* You can use the "r" and/or "R" keys to move the cursor to a
desired location, and you can clear the entered number by
touching the "Delete" key.
6. Touch the "Password" key.
7. If necessary, use the keypad to enter the predetermined F-Code
password.
* The password can be up to 20 digits in length and can include
any combination of the numerals 0 - 9 and the symbols "*" and
"#".
* This password is not required if you agree in advance with the
destination party not to use one.
8. Touch the "Close" key.
The message display will return to the same screen as was
displayed in step 2. You can now change any transmission settings
that you want or set the time for the transmission to begin.
9. Press the Start key. The transmission operation will begin.
4-20

(4) Printing Out an F-Code Relay Box List

Print out this list in order to check the information registered for each
F-Code Relay Box.
* If there are no F-Code Relay Boxes registered in this fax, an F-Code
Relay Box List will not be printed out.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1. Touch the "Print Report" key. The Report Selection screen will
appear.
(Inch)
(Metric)
2. Touch the "Subad. rel box list" key.
(Inch)
(Metric)
3. To print out an F-Code Relay Box List, touch the "Yes" key. An
F-Code Relay Box List will be printed out.