Initializing Settings - Star HSP7000 SERIES Hardware Manual

Initializing Settings


Set the push switch as described below to initialize the
setting information.
(1) Push the switch for one to five seconds while run-
ning under normal operating mode.
The green and red LEDs will flash with a regular
pattern.
(2) After that, push the switch once again in that state
to turn OFF both of the red and green LEDs. This
will return the settings of the interface board to
their default, or ex-factory, settings.
(3) After the interface board has been initialized, the
printer will automatically reboot itself.
LED Display

Green : Lights when other party connection is
recognized as 100BASE-TX.
Red : Lights when packets are received.
– 63 –
Push Switch
LED