Scanning Micr Characters - Star HSP7000 SERIES Hardware Manual

4-4. Scanning MICR Characters

The insertion direction for MICR paper varies according to the model.
HSP7543 (no MICR scanning head): MICR characters cannot be scanned.
HSP7643 (MICR scanning head installed above):
HSP7743 (MICR scanning head installed below):
Insert a MICR paper as follows:
(1) Turn the printer power switch ON.
(2) Make sure the SLIP lamp is flashing.
(3) As you face the printer, insert the paper straight, while sliding the right end of the MICR
paper against the right end of the slip paper slot.
Note: Sliding the paper diagonally can cause a paper jam.
If the paper gets jammed, press the RELEASE button to remove the paper. Then,
insert the paper again. (See "8-2. Removing Paper Jam" for details.)
(4) When the MICR paper reaches the scanning position, the SLIP lamp will turn ON.
<Direction of MICR Paper on HSP7643>
<Direction of MICR Paper on HSP7743>
Insert the MICR paper with the MICR characters facing
up.
Insert the MICR paper with the MICR characters facing
down.
Scanning
characters
Scanning
characters
– 21 –