Table of Contents
Advertisement
(4) Using the tip of a ballpoint pen or a similar object, set the DIP switches as follows: DIPSW1-4
and DIPSW1-5 OFF, DIPSW1-6 ON, DIPSW1-7 OFF, and DIPSW1-8 ON. Turn the printer
power ON. The lamps on the control panel will flash, and the printer will enter the sensor
adjustment mode.
(5) Using a small slot screwdriver, turn VR4 as shown below, and adjust it so that all the lamps
are lit: POWER lamp (green: constant ON), ERROR lamp (red), PAPER OUT lamp (red),
and SLIP lamp (green).
(6) Turn the printer power OFF, and restore the DIP switches DIPSW1-4, DIPSW1-5, DIPSW1-
6, DIPSW1-7, and DIPSW1-8 to their original settings.
6-5-5. TOF Sensor Adjustment Mode
(1) Make sure the printer power is turned OFF.
(2) Insert a slip paper to set the printer in the "paper present" state.
To do so, open the front cover and insert the paper diagonally from the left. Set the paper
straight while pressing on the platen. Then, close the front cover.
See the illustration under "6-5-4. COF Sensor Adjustment Mode" for instructions on how
to set the paper in place.
(3) Undo the screws and remove the DIP switch cover from the bottom of the printer.
(4) Using the tip of a ballpoint pen or a similar object, set the DIP switches as follows: DIPSW1-4
OFF, DIPSW1-5 ON, DIPSW1-6 and DIPSW1-7 OFF, and DIPSW1-8 ON. Turn the printer
power ON. The lamps on the control panel will flash, and the printer will enter the sensor
adjustment mode.
VR1
VR3
1
VR2
VR4
1
VR5
– 39 –
2
3
4
5
6
7
8
9
10
2
3
4
- Quick Links:
- Errors
Hide quick links:
Advertisement
Table of Contents
