Ethernet Interface Model - Star HSP7000 SERIES Hardware Manual

11-4. Ethernet Interface Model

ON
OFF
No. 1 2 3 4 5 6 7 8
Switch
1-1 Emulation
1-2 STAR line mode
ESC/POS mode
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment
1-5 Should not be changed (Should be set to on)
1-6 Handshaking conditions (conditions for
BUSY)
1-7 ASB Function *1)
1-8 Star Line Mode
ESC / POS Mode
1-9 Low-power consumption mode
1-10 Validation status in standby condition print-
ing
The factory settings of DIP switch are all on.
*1) ASB Function
When this function is enabled, status information is automatically sent to the host whenever the printer status changes
(such as when the cover is opened, paper runs out, or an error occurs). For information about automatic status infor-
mation transmission, refer to the separate Programmer's Manual (Star Line Mode and ESC/POS Mode).
*2) NSB Function
When this function is enabled, status information is sent automatically whenever the printer enters into reverse for-
warding mode. For information about automatic status information transmission, refer to the separate Programmer's
Manual (Star Line Mode and ESC/POS Mode).
Note:
The functions of ASB and NSB will be supported depends on the difference of the firmware version in the
Ethernet I/F card. Previous version before IFBD-HE05 Ver.1.0.1: unsupported (Please note that the test printing con-
figuration can be printed however, the function is disabled)
IFBD-HE05 Ver.1.1.0 or later: supported
Switch
2-1~2-4
The factory settings of DIP switch are all on.
9 10
DIP-SW 1
Function
Reserved
Resolution correc-
tion
NSB Function *2)
Reserved
Function
Always ON
ON
OFF
No. 1 2 3 4
DIP-SW 2
DIP-SW 1
STAR line mode
Always ON
203 dpi
Invalid
Offline or receive
buffer full
Valid
Valid
Should not be changed (Should be set to on)
Invalid
Opening the platen
DIP-SW 2
– 62 –
ON
ESC/POS mode
180 dpi
Valid
Receive buffer full
Invalid
Invalid
Valid
Closing the platen
ON
Should be set to on
OFF
OFF