Star HSP7000 SERIES Hardware Manual page 14

3-2-5. Connecting Ethernet Interface Cable
To protect the unit from electromagnetic interference, affix the two supplied ferrite cores to the
printer and router (hub) sides of the cable, respectively. Follow the instructions given below.
Option: LAN CABLE 1.0 M TSP1E (P/N: 30729200)
(1) Make sure the printer is turned off.
(2) Affix the ferrite core onto the Ethernet cable as shown in
the illustration below.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the cable and lock it. Use scis-
sors to cut off any excess.
Ferrite core
(5) Connect the interface cable to the connector on the
rear panel of the printer.
Link disconnection detection feature
The Ethernet interface model is equipped with a link
disconnection detection feature.
If the printer is turned on when an Ethernet cable is not
connected to it, the POWER and ERROR lamps are
simultaneously turned on and off at 2-second intervals
to indicate the disconnection.
Be sure to connect the Ethernet cable from a PC or hub
to the printer, and then turn the printer on.
Ethernet cable
Fastener
10 cm
(maximum)
– 10 –
Pull and cut