Star HSP7000 SERIES Hardware Manual page 40

(5) Using a small slot screwdriver, turn VR1 as shown below, and adjust it so that all the lamps
are lit: POWER lamp (green: constant ON), ERROR lamp (red), PAPER OUT lamp (red),
and SLIP lamp (green).
(6) Turn the printer power OFF, and restore the DIP switches DIPSW1-4, DIPSW1-5, DIPSW1-6,
DIPSW1-7, and DIPSW1-8 to their original settings.
6-5-2. NE Sensor Adjustment Mode
(1) Make sure the printer power is turned OFF.
(2) Open the rear cover and remove the paper roll, thus setting the printer in the "paper absent"
state.
(3) Undo the screws and remove the DIP switch cover from the bottom of the printer.
(4) Using the tip of a ballpoint pen or a similar object, set the DIP switches as follows:
DIPSW1-4, DIPSW1-5 and DIPSW1-6 OFF, and DIPSW1-7 and DIPSW1-8 ON. Turn
the printer power ON.
The lamps on the control panel will flash, and the printer will enter the sensor adjustment
mode.
VR1 VR3
1
VR2 VR4
1
VR5
– 36 –
2 3 4 5 6 7 8 9 10
2 3 4