Usb/Poweredusb Interface Model - Star HSP7000 SERIES Hardware Manual

11-3. USB/PoweredUSB Interface Model

ON
OFF
No. 1 2 3 4 5 6 7 8
Switch
1-1 Emulation
1-2 STAR line mode
ESC/POS mode
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment
1-5 USB mode
1-6 Handshaking conditions (conditions for
BUSY)
1-7 ASB Function *1)
1-8 Star Line Mode
ESC / POS Mode
1-9 Low-power consumption mode *3)
1-10 Validation status in standby condition printing
*1) ASB Function
When this function is enabled, status information is automatically sent to the host whenever the printer status changes
(such as when the cover is opened, paper runs out, or an error occurs). For information about automatic status infor-
mation transmission, refer to the separate Programmer's Manual (Star Line Mode and ESC/POS Mode).
*2) NSB Function
When this function is enabled, status information is sent automatically whenever the printer enters into reverse for-
warding mode. For information about automatic status information transmission, refer to the separate Programmer's
Manual (Star Line Mode and ESC/POS Mode).
*3) The settings will be invalid (always low-power consumption mode) when a PoweredUSB
is being used.
The factory settings of DIP switch are all on.
Switch
2-1~2-4
The factory settings of DIP switch are all on.
9 10
DIP-SW 1
Function
Reserved
Resolution correc-
tion
NSB Function *2)
Reserved
Function
Always ON
ON
OFF
No. 1 2 3 4
DIP-SW 2
DIP-SW 1
STAR line mode
Always ON
203 dpi
Invalid
Vendor class
Offline or receive
buffer full
Invalid
Valid
Should not be changed (Should be set to on)
Invalid
Opening the platen
DIP-SW 2
ON
Should be set to on
– 61 –
ON
ESC/POS mode
180 dpi
Valid
Printer class
Receive buffer full
Valid
Invalid
Valid
Closing the platen
OFF
OFF