General Procedures and Information
GP 9 Environmental Conditions
When selecting the machine's location, the following factors should be taken into consideration:
•
The room should be adequately ventilated.
•
A standard single-phase power socket with earth (rated in conformance with the information
on the label at the back of the machine) should be located no more than 2 meters (78
inches) from the machine. This socket should be easily accessible.
•
For easy access to the machine and to allow the different machine covers to be opened eas-
ily, leave a space of at least 30 cm (12 inches) on each side and at the back. Make sure that
there is sufficient space in front of the machine.
•
Never place the machine where it is under direct sunlight, heating radiators, air-conditioners,
Avoid areas with frequent vibrations.
•
Avoid areas where water or other products may be splashed on to the machine.
•
Never place the machine directly on the floor.
•
Always place the machine on a sturdy, flat surface.
•
Always keep the machine away from hanging objects and any inflammable products.
6-24
04/08
Phaser 3100 MFP