General Codes - Xerox Phaser 3100MFP Service Manual

RAP 1 Error Codes
Scanning and Communication Error Codes
The communication error codes appear in the logs (printed using key sequence 5 4) and in the
transmission reports.

General Codes

The following table presents and details for each error code displayed by the machine its cause
and when required the corrective action to perform.
Code
01 Engaged or no fax tone
03 Stopped by operator
04 Programmed number invalid
05 Scanning fault
06 Printer not available
07 Disconnect
08 Quality
Phaser 3100 MFP
Error
This code appears after 6 failed attempts.
Communication stopped by the operator by
pressing the STOP key.
Invalid programmed single-key or quick-
dial number (Example: a delayed transmis-
sion has been programmed with a single
key and this key has been deleted).
An error has occurred at the location of the
document to be transmitted (Example: the
sheet is jammed).
An error has occurred on the printer
(Example: out of paper, paper jam or cover
open). In the case of a reception, this inci-
dent code only appears if the RECEPTION
WITHOUT PAPER
W ITHOUT P APER .
The communication has been cut (bad
connection).
The document that you have transmitted
has not been received correctly.
Table 1:
Cause
parameter is set to
04/08
Status Indicator RAPs
Action
Restart the transmission
at a later time.
Check the validity of the
programmed number
and/or the single-key
associated to the pro-
grammed number.
Check the ADF module.
Check the printer.
Check the called number.
Contact your corre-
spondent to check
whether it is necessary to
retransmit the document:
the interference may
have occurred in an
unimportant area of the
document.
2-3