Please Load Xxx; Error - Epson StylusPRO 7000 Service Manual

EPSON Stylus Pro 7000
Table 3-8. Please Load xxx
Item
LCD

Please Load xxx

message
Paper check indicator is on and the currently selected paper path
LED indicator
indicator flashes. The paper path information is supplied by the
status
PP remote command.
Roll paper and cut sheet size settings differ.
The PP remote command determines the paper path, and when
Details
this setting and the paper setting made via the control panel
differ, this (paper mismatch) error occurs.
Load the correct paper size, or change the setting in the control
Recovery panel/driver to match the size of the paper loaded in the printer.
When this error clears, printing begins.
Table 3-9. Paper Path Command and LED Indicators
Roll
PP Command
Auto Cut
Roll Paper Flashing
Cut Sheets On
Troubleshooting
Description
Roll
Sheet
No Cut
Flashing On
On Flashing
Troubleshooting Using the Error Messages
Table 3-10. Please Load Paper
Item
LCD
Please Load Paper
message
LED indicator
The Paper Check indicator in on.
status
The Paper Set Lever is in the release position.
Details
While loading paper, the Paper Set Lever was pushed to the
release position.
Pull the Lever forward to the paper set position to clear the error.
If the error doesn't clear, check the Paper-Set-lever position
Recovery
sensor for dust or foreign material. Also make sure the sensor is
properly connected to the Main board.
Table 3-11. Paper Jam
Item
LCD
Paper Jam
message
LED indicator
Paper Check sensor flashes
status
There is a paper jam.
During a printing, feeding, or cutting operation the paper
Details
jammed on a printer part. A paper jam is detected when one of
the paper-edge sensors is on and the CR motor has an out-of-
step error or an overcurrent error is detected.
Remove the paper from the printer, turn the printer off and back
on, and try to print again. If the error recurs, make sure nothing
Recovery
blocks the carriage path and there are no foreign objects inside
the printer.
Revision A
Description
Description
88