Adjustment Steps; Parameter Backup; Requirements For Backup - Epson StylusPRO 7000 Service Manual

EPSON Stylus Pro 7000

5.2 Adjustment Steps

This section describes the detailed steps for performing the adjustment
procedures listed in Table 5-2.

5.2.1 Parameter Backup

The Main Board contains NVRAM (EEPROM) which is used to store the
parameter information and firmware commands that control the printer. For
all corresponding printer parts, the individual and unique adjustment
information and part codes are stored here, which allows the Main Board and
Printer Mechanism to work together smoothly. This information includes
adjustment parameters and must be kept up to date for the printer to work
properly.
Therefore, to replace the Main Board, you need to
"
back up the parameters as described below
"
replace the C299 Main board as described in Chapter 4
"
download the parameters as described on the next page
"
upload the firmware as described on page 160
"
adjust the sensors as described on page 166.
Adjustment

REQUIREMENTS FOR BACKUP

"
#F727 Flash Memory Card (1050073))
(Conforms to PCMCIA Rel 2.1/JEIDA Ver 4.2 (Type II) / 5V Read/Write
operation)
Part # 1050073 (Fujitsu: MB98A81183-15)
"
Memory card writing utility
(i.e. Adtech CardUT97)
"
PC with memory card writer or stand alone memory card writer
"
IPL contained in the #F733 Self-Training Kit
Self-Training Kit code: 1053426
Folder: \Tool\Backup\
File: Pbuset_B.Bin
Before backing up the parameters to the PC card, the above file must
be copied to the Flash Memory Card:
The backup card you use in these steps only works with the
C A U T I O N
Stylus Pro 7000; do not attempt to use it with other printers.
Adjustment Steps
Revision A
157