EPSON Stylus Pro 7000
3.4 General Errors
This section describes error that can be solved by the user.
C H E C K
By using "Check: Test" function in the built-in self-diagnostic
P O I N T
mode, you can check control panel, sensors, encorders
function. Refer to Chapter 5, Adjustment, for more details.
INK LOW
"
Problem
An ink end sensor has detected that the corresponding ink cartridge is
almost empty (ever ink cartridge has an ink level gauge). It is possible
to print about 100% duty on B1 size paper with the remaining ink, but
the cartridge should be replaced as soon as possible.
If you re-install an ink cartridge that was detected as being in a "Near
End" state, the status will immediately go to "Ink Out". Only install
new cartridges.
"
Solution
Replace the ink cartridge.
C H E C K
If for any reason you replace an ink cartridge before it reaches
P O I N T
the ink-low or ink-out state with a new ink cartridge, you need
to reset the ink counter using the control panel and
Maintenance Mode 2.
Troubleshooting
PAPER OUT
"
Problem
!
Paper is not loaded.
!
The rear edge of roll paper has been detected.
!
The print job using cut sheets is finished or the rear edge of cut-sheet
paper has been detected.
"
Solution
!
If paper has run out, remove the printer paper and load new paper. If
print data remains in the printer, the data will be printed.
!
If this error occurs even though paper is properly loaded, there may
be something on the P-Rear sensor's surface. Clean the sensor's
surface (hole in the Paper Guide, Upper) with a clean, dry cloth.
C A U T I O N
Use a clean, dry cloth when cleaning sensors; never use a wet
cloth or soap.
General Errors
Revision A
99